StuWireless Setup for Macintosh 10.5Wireless access is available throughout campus. A wireless network card that supports WPA2 is required in order to use the StuWireless network. The following documentation applies to Mac OS X version 10.5 and above using the built-in AirPort software.
Wireless Setup for Macintosh OS 10.5 Leopard
If you have previously registered your wireless card on the TCU network, then skip to Part 3.
Part 1: Find your Wireless Network Address in Macintosh OS 10.5
- Go to System Preferences and click the Network button
- Click the AirPort button on the left side of the bar and click the Advanced button
- Write down the AirPort ID located at the bottom of the window

Part 2: Register your Wireless Network Address
- Login to http://my.tcu.edu/
- Choose Helpful Links from the menu
- Choose the link: TCU Network Registration

- Carefully read the TCU Computing Resources Policy and click Accept to continue.

-
For the Subnet, choose: Student-Wireless
-
Fill in Computer Operating System Type: Macintosh OSX.5 (for 10.5)
-
Fill in the Network (Ethernet) Address
-
For My Description, write a short description for the computer registered, i.e. "Frog's Ethernet", for easy identification.
-
Click the Save button

Part 3: Wireless Setup for Macintosh OS 10.5
- From the menu bar, click the Airport icon and make sure AirPort is turned OFF.

- Choose Open Network Preferences

-
Select
Airport on the list of devices and click the
Advanced button

- Make sure AirPort is selected on he top menu bar. Click the "+" sign under the box.
Make the following selections and entries:
Network Name: StuWireless
Security: WPA2 Enterprise
Username: ** Leave Blank **
Password: ** Leave Blank **
802.1X: Automatic
Check the box that says Remember this network
Click Add

- Go back to the wireless icon and turn AirPort ON
- Select the network name StuWireless
- Once the 802.1X Authentication pops up, Enter your TCU Username and Password

- Click Show Certificate if the Verification Certificate appears.
- To accept the certificate permanently, click Show Certificate, then highlight the certificate shown below: acswireless.tr.tu.edu.
Click the selection arrow next to Trust and change the setting for al three dropdowns to Always Trust. Put a check mark in the box to Always trust "acswireless.tr.tcu.edu".
- Press Continue. You should now be connected to the TCU Student Wireless Network.
Configuration of StuWireless is complete!